FS: 911 RSR Style Headers
 

911 RSR style headers 1.5 inch diameter inlets for sale.

$200 plus shipping takes the pair. O2 bunge installed.

Bill Pickering
e-mail: nine14cats@yahoo.com
(408) 410-9005

http://forums.pelicanparts.com/uploa...1154708597.jpg

headers
 

I'm looking for a set for a 3.2 conversion would this work on a 3.2? the car is a street car . Can I add a muffler if I want to?

Please let me know

Fred

Yes, these headers would work with your car. They are 1.5 inch diameter inlets, so the low end torque would be good but you would run out of air at the top if you are building a 3.2 hot rod. If you're staying stock DME, you would be fine. You can add a cat and muffler to them if needed. Smog laws vary by state.

The other thing to consider with headers is that you will loose your Heat Exchangers and the use of your heater.

Let me know.

Thanks,

Bill Pickering
e-mail: nine14cats@yahoo.com
(408) 410-9005

You've got mail, Bill. I'd like to get in line behind Fred.

Bill please let me know how much for shipping to 78258 you can e-mail goldsc_78258@yahoo.com

Fred

Fred, if for any reason they don't work for you, let me know.

Rick, I PM'd you.
-Jon

Sorry to but in. Fred do your research, if I remember right 1.5" is too small for a 3.2 I believe you need 1.75". A good way to know is to call Euro Headers they'll tell you.

Hi Guys,

I've got an update:

1. Fred (If they are good for his application)

2. Zoanas (Rik) If Fred cannot use them.

Armando,

No problem butting in. In fact, I do not want to sell something to someone that doesn't work.

Fred,

You may want to speak with other's on Pelican or your mechanic. I'm going off a book I have on 911 motors and exhaust sizes. But in real world applications, I haven't done one of these yet. I've only had experience with 2.7's and 3.6's.

Let us know what you would like to do. If you pass, Rik is next up.

We will wait for your answer.

Thanks and Best Regards,

Bill Pickering
e-mail: nine14cats@yahoo.com
(408) 410-9005

I will post on the engine forum and should have an answer by tomorow

Fred

Thanks Fred. Just let me know tomorrow or when you get the answer from the folks in the engine forum.

Thanks and Best Regards,

Bill Pickering
e-mail: nine14cats@yahoo.com
(408) 410-9005

I'd like to be in line as well. I think I'm behind Rik.
Best
Rick

Bill Not sure as of yet so let Rik(Zoanas) take them

Thanks for your patience

Fred

Hi Fred,

No Problem.

Rik,

Do you still want the headers? If not, Rick #2 is next in line.

Thanks,

Bill Pickering
e-mail: nine14cats@yahoo.com
(408) 410-9005

Rick2, they're yours. I think I need the 1-5/8".

Bill, sent you a PM.

Thanks for the interest guys.

Rick2, PM back at you.

Best Regards,

Bill Pickering
e-mail: nine14cats@yahoo.com
(408) 410-9005