WTB engine sheet metal for 2.4 MFI

[nein4teen]

Looking for the two engine tin pieces for 2.4 MFI, the ones on the pump cam drive end of engine. Rough surface finish is ok, but prefer no bent or damaged pieces. Thanks in advance.

[dporsche74]

are these the ones you need,

55 shipped Ok


K

[c2kid]

aloha, i have an outer. i think you can use a regular one for the inner and just cut a hole for the pulley shaft and drill 3 holes for the bolts to the cam carrier. i'm thinking $50 boxed and mailed to you. cheers, geoff

[nein4teen]

I should have clarified a little. This is for a 914-6. I have a set of new aftermarket 914-6 tin, but it's not shaped for MFI applications, i.e. no allowance for cam drive belt. So I will be trying to mate the 911 MFI tin and the 914-6 tin. Open to suggestions from any others who may have done this.

[nein4teen]

Originally Posted by dporsche74

are these the ones you need,

55 shipped Ok


K

those look kinda beat up. do you have better photos?

[nein4teen]

Originally Posted by c2kid

aloha, i have an outer. i think you can use a regular one for the inner and just cut a hole for the pulley shaft and drill 3 holes for the bolts to the cam carrier. i'm thinking $50 boxed and mailed to you. cheers, geoff

Thanks but I need both inner and outer halves.

[rennworks]

Drporsche74, do you still have these available?
Warren

[dporsche74]

yup still those peices

[rennworks]

Sent you a PM