WTB rubber hand brake cable grommet

[mgro1959]

A while back I advertized for these but did not have picture or part number. I managed to glue the 4 rubber almost complete item back together. This is fitted over the cable and back by the rear axle there is a tab thru which the brake lines go thru enroute to the rear calipers. This is the transition point from steel fwd line to flexible line which goes back to steel line into the caliper. On the bottom of the tab this grommet presses into a c shaped slot and the groove in the center of this squashes into the slot and holds cable up and out of the way of the axle. Does anyone have these or are they available. I looked under the chassis of a mint 14K mile 78 930 but it did not have this setup. Mine is an 86 carrera so maybe on later cars. Any help or leads greatly appreciated. Maybe it was part of the cable but even if you made a cut down the side to fit it would hold together when pressed into the c shaped tab hole. Imagine the glow stick as the brake cable.Thanks Rob