Clutch Cable / Pulley Configuration

[dc914guy]

Hello All~
Could someone please post a picture, or some information on how the clutch cable hooks up to the pulley on the transmission, and then to the throw out bearing? I do not recall how the whole setup came together when I pulled the motor many months ago

Any pictures and help would be great!

Thanks,
~Eric

[Dave at Pelican Parts]

The following picture is from the Clutch Replacement tech article elsewhere on this very site. You can find it at http://www.pelicanparts.com/techarticles/914_clutch_replace/914_clutch_replace1.htm



--DD

[red-beard]

The least they could have done would have been to clean the tranny before the shot. YUCK!!!!

My fingers are getting dirty just looking at it...

James

[1bad914]

Call me a woosy, but I wear latex gloves all the time! I like to think that I am a 914 surgeon...a bad one! I fear no grease!

[red-beard]

I don't wear the gloves often enough. I wore them last weekend and will today, since I have someone coming to visit this week, and I do not want deep dirt.

James