Next Megasquirt 914

[3D914]

I'm in the last phase of constructing the Megasquirt for my 74' 2.0L and I have some specific questions for anyone thats "been there, done that"


[list=1][*]Did anyone use the D8 diode for their 914, and if so, why?[*]Resistors R4 & R7 can be changed to match the different coolant and air temp sensors. If I'm using stock sensors, what are the suggested resistor values for these?[*]For the XG1 - XG2 jumper; was it necessary to change this so that XG1 jumpers to an external ground via X11?[*]Was it necessary to increase the resistance value of R10 from the default 390 ohms?[/list=1]

So far everything has progessed nicely. The only glitch has been a bad POT on the stimulator, but its not a show-stopper.

Many thanks,

[Alfred1]

DNHunt on the 914club board put a megasquirt on his 914. He might be able to help you.