Pelican Parts Forums

Pelican Parts Forums (http://forums.pelicanparts.com/index.php)
-   Porsche 914 & 914-6 Technical Forum (http://forums.pelicanparts.com/forumdisplay.php?f=7)
-   -   Acceptable rotor runout (http://forums.pelicanparts.com/showthread.php?t=78555)

Zeke 08-24-2002 04:08 PM
Acceptable rotor runout
 
I asked this question over on 911 BBS as a reply to something about Pagid pads. But I really need to start a thread to find out how much runout is OK on ventiated rotors. The "answer man" over there says read the spec book and see that the answer is 0.05mm. What is that? Five one hundreths of a mm? Can some American mechanic tell me in thousandths of an inch? Seems that my dial indicator reads in 1000ths and so do I. TIA

JWest 08-24-2002 06:45 PM
0.05mm / 25.4 = 0.00197in

Joe Bob 08-24-2002 07:00 PM
http://www.onlineconversion.com/

Good source for converting stuff...


All times are GMT -8. The time now is 07:40 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website


DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.