|
|
|
|
| Author |
|
|
Registered
|
Help with exhaust
Hoping for some pointers. PO stuck an aftermarker muffler on the car.
Everything from the cat back seems to hang from one rubber hanger attached to the muffler. From underneath the car I see too hooks (spare tire well area) which look like they were at one point used for stock muffler support. With just the 1 support point now I can move the muffler about 15 degrees on its horizontal axis, pretty crappy i think. Where else on the undercarriage are there supports for exhaust hangers?
__________________
''87 944na 85k C02 / M158 / M418 / M425 / M431 / M454 / M533 / M650 / M946 '94 Oldsmobile 88 Royale (winter beater) Its not what you drive, its what drives you. |
||
08-11-2005, 05:04 PM
|
|
|
Registered
Join Date: May 2005
Location: Tucson
Posts: 203
|
Youll have to jack it up to make sure its still connected, but theres a hanger right before the cat, and the 2 hooks by the spare were used to hand the oem exhaust.
__________________
-Gabe -black 1988 924s, 944 turbo sway bars, LSD, gunmetal phone dials-- SOLD to some people who cannibalized her -1987 MR2 ---ONLINE REP FOR RADMACHER PORSCHE SERVICE IN TUCSON--- |
||
|
08-11-2005, 05:39 PM
|
|
|
meister member
|
You can buy new rubbers from the dealership. To make installing them easier I rubbed the slots with liquid dish soap.
__________________
1983 944 guards red with 16" Fuchs, Host of Wisconsin area timing/ balance shaft belt tensioning party 1987 944S Purchased from Legion. Corvette LT-1 V-8 conversion with Mega Squirt II Check on progress ---> www.porschehybrids.com/gallery/speedracing944 Favorite Road = www.tailofthedragon.com 318 turns in 11 miles (11 min 20 sec best run) |
||
|
08-11-2005, 06:02 PM
|
|
1987 Porsche 944 2.5L 4 Cyl, 8 Valves
