924 Custom Leather Dash Speaker Delete
 

I just finished this custom job. I covered the speaker with PVC plastic, filled and feathered the edges. I also re-cut the defroster vent area for an aftermarket trim piece and added an embroidered Porsche crest in red.
A job like this runs $900

http://forums.pelicanparts.com/uploa...1182822685.jpg
http://forums.pelicanparts.com/uploa...1182822734.jpg
http://forums.pelicanparts.com/uploa...1182822777.jpg

Looks good... what's the cost?? :)

A job like this runs $900

lol... ok. That stuff is expensive! There is another guy in the "D" that does it for $800 I think. No Porosche logo, but I would worry about it getting fraied in my car.

I see you added to you signature line! Same place, maybe my numbers are off a little.

Isn't there a fastener behind the center speaker grille that holds the dash to the chassis? Oh, and that defroster vent? Very nice.

Nice job Rob!!!!

How do you bolt up the dash if you covered the speaker grill, through the aftermarket piece???

My car smells like a new one. Everyone that has sat in it loves the seats.

Thanks Jim. I finally got around to making up new seats for car. Now all I have to do is get them put in, but not until the rest of the interior is done. Maybe by Labor Day.

As far as bolting it in, I guess that's up to the owner. Since the speaker isn't there, you can access the bolt hole from underneath.

I just got my hood liners from you guys... very nice, and VERY helpful!