FS: Garrett TO4E Dual Ball Bearing Turbo

[robm-951]

This is a dual ball bearing Garrett TO4E Turbo. it's a 50 trim compressor with a stage III turbine inside a Turbonetics replica #8 turbine housing that bolts to the factory crossover and downpipe.. The compressor housing is the standard TO4E 3" inlet and 2" outlet.

The bearing center was just sent to a Garrett authorized performance dealer where everything was checked out, re-sealed and re-balanced and it has 0 hrs on it.

Included is a braided -an oil feed line and adapter to connect to the balance shaft cover, a custom water pipe, adapters for the water connections and a low profile thermoswitch. With this waterpipe and adapters, you can run a standard thermoswitch if you prefer since this setup puts the switch out from under the throttle body/intake. The down pipe is also included and has all good studs that have been replaced as well as copper exhaust nuts. I will also throw in an alternator cooling shroud that has had the hump removed and epoxied over.

Asking $1100 shipped to the lower 48

[robm-951]

Bump

[robm-951]

Sold. Thanks Guys!