|
|
|
|
|
|
Architecture & Porsche's
Join Date: Jan 2006
Location: Austin, Texas
Posts: 3,189
|
'81 928 5-speed track-car for sale: $6900
Selling our beloved Penny due to GT2-spec 928 racecar build-up (another project). Rescued from a Pawn Shop in 2006, she has gone through the wringer getting up to par & reliable. Asking price is $6900, below is our list of maintenance & modifications.
All work performed by 14-year PCA member & co-member with experience building/rebuilding/restoring 928’s with extensive 928 maintenance experience: engine rebuilding, clutches, suspension work etc, utilizing factory 928 manuals & torque-specs. Engine: Completely re-sealed engine in 04/07 including: -bare long-block re-seal: -reseal heads (headgaskets, OEM) -cleaned, painted, intake manifolds with new gaskets -cleaned & re-hosed (Goodyear EFI hose with EFI hose clamps) fuel injectors -Rebuilt front fuel hoses (Goodyear EFI w/EFI clamps) off hard lines in engine -all new zinc-coated engine bolts including anti-seize -most all breather hoses are new, including brake booster. -front & rear main seals -New T-belt, Rebuilt tensioner, rebuilt water pump, new idler & tensioner rollers -Re-seal oil pump with new bolts -New 73c low-temp thermostat & seal -New Battery in 02/08 Hydraulics: -Master Cylinder has been replaced before (left alone), new soft-hose feed line. -New OEM clutch-master cylinder & new hard line from master cylinder -New OEM clutch slave cylinder & hard line -Correct Early 928 Proportioning valve for better braking Clutch: -Tested used pressure plate, good clamping force -Clutch discs: both are OEM new, perfect shape -Cleaned & tested intermediate plate -Cleaned & smoothed OEM flywheel -New Pilot bearing -New Throw-out bearing (release bearing) -New/Used guide tube -New flywheel bolts (Grade 10.8) -New release arm bushing -New Soft fluid clutch hose Brakes: Front Brakes: ’87 928S4 spindles with re-packed bearings using Amsoil grease -Factory Porsche OEM Front S4 rotors with painted hats -Factory 928S4 Front Calipers (painted Red via G2 kit), new OEM Caliper Bolts -PBR Street/Track pads (no squeal) Rear Brakes: New OEM rear rotors with painted hats. -PBR Street/Track pads (no squeal) Suspension: -Sport springs front, stock shocks with added threaded spring perches ft/rear -928S4 front sway bar with Energy suspension bushings. Steering: -OEM Rack, no leaks. -New Tie rods & boots, both ends -Redline Power Steering fluid & re-sealed low-pressure line Cooling: -Phosphate-free coolant added with 1pt Water-wetter after full cleanse & flush. -New coolant hoses added where needed -New low-temp 73c thermostat & o-ring -Mechanical fan delete due to air pump idler -High-performance 16” pull-fan installed at backside of radiator. Exhaust: -OEM Cast manifolds (new gaskets), & y-pipe, new Bosch O2 sensor -Fresh aluminized-steel 2.5” straight exhaust with single stainless 2.5” dual Tip muffler hung at rear. Incredible song!! Electrical: -All normal electronics needed to power vehicle & pass inspection are fine. Fluids: -Brad Penn Racing oil: 20w50 -Redline Transaxle fluids: 4 quarts Shockproof, 2 quarts MTL -ATE Super blue Brake fluid Transaxle: -Stock ’81 transaxle & torque tube: So/so syncro’s for 1st, reverse. 2nd & 3rd are easy enough to find & 4th & 5th are perfect. Transaxle has 2.75 rear end (short gears for a 928), so for most courses and with the V8, 4th & 5th are most commonly used. Shift linkage was rebuilt: new front pivot bushing on front of shaft, center support for front shaft has been reinforced, new shifter springs & bushings, a new rear shaft was substituted for worn rear shaft, & rear u-joint was rebuilt with new bushings. Wheels & Tires: Car comes with Factory Dish wheels with so/so Yokohama tires for listed price. 18” 993 Cup wheels with new SO2’s in the rear (265/35-18) + so/so 225/40-18 SO3’s in the front are available for $1000 more. ROH Modena’s pictured not for sale. Penny was copper (yes), but now has a fresh flat-black & semi-gloss-black racing paint job: good enough for track, good enough to get the car around, not good enough for showing. Interior is stripped of all interior dressing with the exception of the headliner & sunroof panel for thermal protection. Only the instrument pod, shifter, & pair of blue/black Corbeau racing seats remain. There is no AC/heating, console, dash, quarters, rear seats, door panels, or carpeting in Penny as she was destined for the track. Great glass, flawless windshield. ![]()
__________________
Porsche Club Racing National Scrutineer '89 Andial 951 '82 928R '74 911 RSR 3.6 |
||
|
|
|
|
Architecture & Porsche's
Join Date: Jan 2006
Location: Austin, Texas
Posts: 3,189
|
![]() ![]()
__________________
Porsche Club Racing National Scrutineer '89 Andial 951 '82 928R '74 911 RSR 3.6 |
||
|
|
|
|
Registered
Join Date: Jan 2005
Location: White Pine, TN
Posts: 147
|
Mark, you have a pm
Reddog928 |
||
|
|
|
|
Architecture & Porsche's
Join Date: Jan 2006
Location: Austin, Texas
Posts: 3,189
|
Penny
Thanks Reddog, I'll check it.
__________________
Porsche Club Racing National Scrutineer '89 Andial 951 '82 928R '74 911 RSR 3.6 |
||
|
|
|