Pelican Parts Forums - Search Results

		Pelican Parts Forums > Search Forums
Search Results

Garage

Page 1 of 2

Showing results 1 to 25 of 27
Search took 0.04 seconds. Search: Posts Made By: kc4ssd

Forum: Porsche 914 & 914-6 Technical Forum

03-21-2016, 05:57 AM

Replies: 19

914-6 Oil scavenge issue

Views: 2,574

Posted By kc4ssd

Thanks again for the input! I am really...

Thanks again for the input! I am really meticulous but when I did it i kept having issues with the chains and my sheet metal rig to hold them. Clearly my mistake and a learner! Beats the $1600 oil...

Forum: Porsche 914 & 914-6 Technical Forum

03-21-2016, 05:28 AM

Replies: 19

914-6 Oil scavenge issue

Views: 2,574

Posted By kc4ssd

OK found my issue! Wound up pulling the motor and...

OK found my issue! Wound up pulling the motor and split the case. Found scavenge green seal laying in bottom of case. I guess when I assembled the halves I knocked one off the groove for scavenge...

Forum: Porsche 914 & 914-6 Technical Forum

01-13-2016, 10:59 AM

Replies: 19

914-6 Oil scavenge issue

Views: 2,574

Posted By kc4ssd

And my question was about keyed?? Is the drive...

And my question was about keyed?? Is the drive gear for for the scavenge and pressure pumps keyed and could have the scavenge broke the key somehow? What boggles me is the lack of others ever having...

Forum: Porsche 914 & 914-6 Technical Forum

01-13-2016, 10:37 AM

Replies: 19

914-6 Oil scavenge issue

Views: 2,574

Posted By kc4ssd

I have bypassed and done everything to isolate...

I have bypassed and done everything to isolate the issue. It is positively plumbed correctly. It still overflows out the top of the crankcase vent when the engine gets hot even with the front circuit...

Forum: Porsche 914 & 914-6 Technical Forum

01-13-2016, 04:53 AM

Replies: 19

914-6 Oil scavenge issue

Views: 2,574

Posted By kc4ssd

Yes I did pull it apart and it is correct,...

Yes I did pull it apart and it is correct, spotless clean. It dumb founds me that the scavenge is not working since the engine was pristine inside and it was a car I owned for 10yr before giving it...

Forum: Porsche 914 & 914-6 Technical Forum

01-12-2016, 07:51 AM

Replies: 19

914-6 Oil scavenge issue

Views: 2,574

Posted By kc4ssd

John, OK Holidays bogged me down and time...

John,

OK Holidays bogged me down and time time for cars! Good holidays though. Last night I 1st bypassed t stat and coupled the lines to straight up front, cold engine started idle no oil pressure...

Forum: Porsche 914 & 914-6 Technical Forum

12-29-2015, 04:46 AM

Replies: 19

914-6 Oil scavenge issue

Views: 2,574

Posted By kc4ssd

OK More info, I did describe the line routing...

OK More info, I did describe the line routing fully accurate as I did not include the tstat. See pic link to see routing of lines. Last night I pulled the sump and screen and it is correct, no debris...

Forum: Porsche 914 & 914-6 Technical Forum

12-28-2015, 10:49 AM

Replies: 2

Could someone help me Fix sliding car seat is stuck.?

Views: 1,056

Posted By kc4ssd

You should be able to release the seat tilt on...

You should be able to release the seat tilt on the side and lift the seat up a bit to look. This is the release on the side and the one to slide would be on the bottom left of the seat. If there is...

Forum: Porsche 914 & 914-6 Technical Forum

12-28-2015, 09:25 AM

Replies: 19

914-6 Oil scavenge issue

Views: 2,574

Posted By kc4ssd

John, Thanks again for your help figuring...

John,

Thanks again for your help figuring this out. The red spin on is my fuel filter. I wanted easy access to my pump and filter. I will take some pics tonight but coming out of the right side of...

Forum: Porsche 914 & 914-6 Technical Forum

12-26-2015, 04:38 AM

Replies: 10

Will PMO ITB's fit?

Views: 1,320

Posted By kc4ssd

They fit. I have twm in my 6. They are not too...

They fit. I have twm in my 6. They are not too tall.

Tim

Forum: Porsche 914 & 914-6 Technical Forum

12-26-2015, 04:35 AM

Replies: 8

Looking For A Cheap Type 4 Engine In Orlando Fla

Views: 688

Posted By kc4ssd

I have a type 4 complete with a rod through the...

I have a type 4 complete with a rod through the case? Free, I'm in Naples.

Tim

Forum: Porsche 914 & 914-6 Technical Forum

12-23-2015, 04:07 AM

Replies: 19

914-6 Oil scavenge issue

Views: 2,574

Posted By kc4ssd

John answers as follows..... The lines are...

John answers as follows.....

The lines are routed down the outside of the rockers, up the inside left fender, through 2 holes with grommets into the fuel tank area, down the rear of tank and under...

Forum: Porsche 911 Technical Forum

12-23-2015, 03:51 AM

Replies: 2

911 914-6 Oil scavenge issue

Views: 413

Posted By kc4ssd

Answers as follows, everything in the oil circuit...

Answers as follows, everything in the oil circuit is new. All new T stat, new #12 lines and fittings and new setrab cooler. I personally assembled everything and then assemebled and blew air through...

Forum: Porsche 911 Technical Forum

12-22-2015, 11:19 AM

Replies: 2

911 914-6 Oil scavenge issue

Views: 413

Posted By kc4ssd

911 914-6 Oil scavenge issue

OK please bear with me as this will involve some info...

On the downstroke of a 914-6 buildout. I had a 80 911 3.0l as a donor car. It was my daily for some 10yr and just beat it up. Upon...

Forum: Porsche 914 & 914-6 Technical Forum

12-22-2015, 11:17 AM

Replies: 19

914-6 Oil scavenge issue

Views: 2,574

Posted By kc4ssd

Thanks Dave, and yes I will post on 911 side too....

Thanks Dave, and yes I will post on 911 side too.

Tim

Forum: Porsche 914 & 914-6 Technical Forum

12-22-2015, 11:05 AM

Replies: 19

914-6 Oil scavenge issue

Views: 2,574

Posted By kc4ssd

John, Much appreciate the response!! As far as...

John,
Much appreciate the response!! As far as changing to AN16 they would never fit where routed. I had a heck of a time with #12. And question though, when you follow the OEM factory 911 service...

Forum: Porsche 914 & 914-6 Technical Forum

12-22-2015, 07:25 AM

Replies: 19

914-6 Oil scavenge issue

Views: 2,574

Posted By kc4ssd

914-6 Oil scavenge issue

OK please bear with me as this will involve some info...

On the downstroke of a 914-6 buildout. I had a 80 911 3.0l as a donor car. It was my daily for some 10yr and just beat it up. Upon...

Forum: Porsche 914 Used Parts For Sale & Wanted

01-31-2014, 06:53 AM

Replies: 8

Fs 914-6 Oil Tank -new

Views: 1,622

Posted By kc4ssd

Do you just have the tank?? I would need the...

Do you just have the tank?? I would need the inlet neck and lines also. Price flexible?

Tim Naples FL.

Forum: Porsche 911 Used Parts For Sale & Wanted

01-29-2014, 04:43 AM

Replies: 7

B&B Exhaust system 911 3.0l

Views: 1,083

Posted By kc4ssd

Sold to David in Chicago! Thanks!

Sold to David in Chicago!

Thanks!

Forum: Porsche 911 Used Parts For Sale & Wanted

01-27-2014, 08:33 AM

Replies: 7

B&B Exhaust system 911 3.0l

Views: 1,083

Posted By kc4ssd

Bump, Any takers for this killer exhaust system

Bump, Any takers for this killer exhaust system

Forum: Porsche 911 Used Parts For Sale & Wanted

01-23-2014, 06:33 AM

Replies: 7

B&B Exhaust system 911 3.0l

Views: 1,083

Posted By kc4ssd

BB Exhaust

Previous buyer fell through, still available. Please note $1500 firm and shipped free ups lower 48. Buyer pays paypal fees!

Forum: Porsche 911 Used Parts For Sale & Wanted

01-22-2014, 06:44 AM

Replies: 7

B&B Exhaust system 911 3.0l

Views: 1,083

Posted By kc4ssd

B&B Exhaust system 911 3.0l

For sale....

Complete B&B Dual in dual out oval rolled tip stainless steel with heat boxes. Was on a 1980 911 SC. It should fit other years, make sure it will fit your application as no returns!...

Forum: Porsche Autocross and Track Racing

11-20-2013, 05:11 AM

Replies: 4

Getting Ready to Part Out 914/6 Racecar

Views: 1,040

Posted By kc4ssd

Please call me about the exhaust. Is it used or...

Please call me about the exhaust. Is it used or new? Is it what is pictured and on the quiet website?

Tim
239-253-4164

Forum: Off Topic Discussions

05-17-2013, 11:54 AM

Replies: 285

The Meanest, Baddest Looking American Muscle Car

Views: 66,923

Posted By kc4ssd

The heck with old, go new school challenger!! I...

The heck with old, go new school challenger!! I have been an old school Guy my whole life and been an air cooled Porsche Guy also forever. Thats what I would stick with old school. New school has the...

Forum: Porsche 914 Used Parts For Sale & Wanted

05-16-2013, 08:00 AM

Replies: 1

original 914-6 oil tank, needs repair

Views: 732

Posted By kc4ssd

What do you what for that tank. Is it cracked?? ...

What do you what for that tank. Is it cracked??

Please call or email me
Tim kc4ssd@gmail.com
239-253-4164

Showing results 1 to 25 of 27

Page 1 of 2

Forum Jump

All times are GMT -8. The time now is 03:40 PM.