Pelican Parts Forums - Search Results

		Pelican Parts Forums > Search Forums
Search Results

Garage

Showing results 1 to 17 of 17
Search took 0.01 seconds. Search: Posts Made By: dr3358

Forum: Porsche 996/997/991 Forum

08-18-2014, 12:29 PM

Replies: 12

996TT and 997TT owners...what's your mileage?

Views: 1,190

Posted By dr3358

2002 996tt 145,000 and running great!!!

2002 996tt 145,000 and running great!!!

Forum: Porsche 996/997/991 Forum

08-16-2014, 08:54 PM

Replies: 0

seat belt connector trick

Views: 503

Posted By dr3358

seat belt connector trick

This is for the seat belt buckle when hooking up the new one because of the dreaded air bag error code. How on earth do you connect the seat belt buckle electrical connector to the large connector...

Forum: 911 / 930 Turbo & Super Charging Forum

01-02-2013, 04:07 PM

Replies: 5

gas smell from cabin tunnel

Views: 1,292

Posted By dr3358

WEll, this has got to be the strangest. I have...

WEll, this has got to be the strangest. I have replaced all fuel lines from the front pump and tank to the rear pump and return. I replaced the vent evap hose as well, coming from the expansion tank...

Forum: 911 / 930 Turbo & Super Charging Forum

11-04-2012, 06:29 AM

Replies: 0

930 shifter vs carrera 4 speed shifter

Views: 481

Posted By dr3358

930 shifter vs carrera 4 speed shifter

does anyone know if a 4 speed 74 shifter part no. 911 464 019 05 will work with a 78 930 4 speed part no. 911 464 019 06?

Forum: 911 / 930 Turbo & Super Charging Forum

10-09-2012, 08:32 PM

Replies: 5

gas smell from cabin tunnel

Views: 1,292

Posted By dr3358

Thanks, Len. I did notice that the PO had...

Thanks, Len. I did notice that the PO had installed a boost controller in the cabin as well and run the lines through the tunnel. He had drilled a hole at the transmission end to have the vacuum...

Forum: 911 / 930 Turbo & Super Charging Forum

10-09-2012, 09:10 AM

Replies: 28

New guy here with a lame 930

Views: 2,266

Posted By dr3358

Agree about the bearings, however don't be afraid...

Agree about the bearings, however don't be afraid of the cv's. Can be replaced fairly easily and easier to replace than rebuild. There are plenty of aftermarket cv's that work well with the 930,...

Forum: 911 / 930 Turbo & Super Charging Forum

10-09-2012, 09:04 AM

Replies: 5

gas smell from cabin tunnel

Views: 1,292

Posted By dr3358

Update!!! Replaced the evap line to the charcoal...

Update!!! Replaced the evap line to the charcoal canister from the tank, without using any expansion tank. Smell seemed to go away, but getting the line through the tunnel revealed two other lines...

Forum: 911 / 930 Turbo & Super Charging Forum

10-07-2012, 05:55 PM

Replies: 5

gas smell from cabin tunnel

Views: 1,292

Posted By dr3358

gas smell from cabin tunnel

After all the posts of gas smells, this one I feel is the worst to tackle. After getting a cabin gas smell in my 78 930 I checked out different posts. Like many other porsches, mine has had the...

Forum: 911 / 930 Turbo & Super Charging Forum

08-03-2012, 08:40 PM

Replies: 6

no power at 4000

Views: 944

Posted By dr3358

Replaced boost overboost switch and problem...

Replaced boost overboost switch and problem solved, except that now I loose power at about 5700-6500. Could be that the engine has close to 175k on it!!

Forum: 911 / 930 Turbo & Super Charging Forum

07-19-2012, 07:22 PM

Replies: 6

no power at 4000

Views: 944

Posted By dr3358

Found that the over boost switch is bad. Grounded...

Found that the over boost switch is bad. Grounded the switch and now pulls good through 5500 rpm. Thanks forum to all!!!!

Forum: 911 / 930 Turbo & Super Charging Forum

07-17-2012, 08:48 PM

Replies: 6

no power at 4000

Views: 944

Posted By dr3358

no power at 4000

1978 930. have all new vacuum lines and they are tight. Except for a faulty AAR the car runs great until it hits just over 4000 rpm. Then there is no power - even on boost. Feels like it is missing....

Forum: 911 / 930 Turbo & Super Charging Forum

06-18-2012, 11:53 AM

Replies: 18

930 distributor signal wire

Views: 2,627

Posted By dr3358

UPDATE!!! Spliced the wire from the distributor...

UPDATE!!! Spliced the wire from the distributor to the CDI. No short in any of the green wire. Now...still no spark! The green wire had shorted (both outer and inner wires touching). The CDI still...

Forum: 911 / 930 Turbo & Super Charging Forum

06-04-2012, 12:02 PM

Replies: 18

930 distributor signal wire

Views: 2,627

Posted By dr3358

Thanks to all!!! Tracing back to the spice...

Thanks to all!!! Tracing back to the spice everything tested OK. Upon removing the green wire from the distributor the connector came off in pieces!!! Had to carefully remove all the broken stuff...

Forum: 911 / 930 Turbo & Super Charging Forum

06-03-2012, 09:51 AM

Replies: 18

930 distributor signal wire

Views: 2,627

Posted By dr3358

Thanks for the advise. Tomorrow I am going to...

Thanks for the advise. Tomorrow I am going to trace this back from the distributor to the CDI. Another engineering marvel.......like the heat exchangers.........

Forum: 911 / 930 Turbo & Super Charging Forum

06-03-2012, 07:45 AM

Replies: 18

930 distributor signal wire

Views: 2,627

Posted By dr3358

930 distributor signal wire

I have a 1978 930. When the engine was out I had to splice my distributor signal wire (the dreaded green wire) I spliced both the inner and outer wires. Now no spark. The replacement wire is a 7 inch...

Forum: 911 Engine Rebuilding Forum

03-06-2012, 07:25 AM

Replies: 2

broken transmission stud

Views: 719

Posted By dr3358

Thanks!!! I now have tonight planned!!!

Thanks!!! I now have tonight planned!!!

Forum: 911 Engine Rebuilding Forum

03-06-2012, 06:39 AM

Replies: 2

broken transmission stud

Views: 719

Posted By dr3358

broken transmission stud

I have a 78 930 and it is all taken apart. I noticed that the transmission stud (the one that has the allen head on top of the starter) broke in half. I assume the extraction is the same as a head...

Showing results 1 to 17 of 17

Forum Jump

All times are GMT -8. The time now is 05:15 PM.