Pelican Parts Forums - Search Results

		Pelican Parts Forums > Search Forums
Search Results

Garage

Page 1 of 2

Showing results 1 to 25 of 38
Search took 0.01 seconds. Search: Posts Made By: Neil - Colorado

Forum: Porsche 924/944/968 Technical Forum

12-25-2018, 08:24 AM

Replies: 2

Filler Neck Sleeve 924S

Views: 273

Posted By Neil - Colorado

Thanks 944 Eco - found it

Thanks 944 Eco - found it

Forum: Porsche 924/944/968 Technical Forum

12-24-2018, 07:29 AM

Replies: 2

Filler Neck Sleeve 924S

Views: 273

Posted By Neil - Colorado

Filler Neck Sleeve 924S

Howdy folks and Happy Holidays!

The Filler Neck Sleeve on my 87 924S has long been expired. This is the boot with the drain attached that you see when you fuel-up.

The P/N for the 924S is...

Forum: Porsche 924/944/968 Technical Forum

09-07-2017, 09:06 PM

Replies: 4

Victor Reinz Camshaft Seal ??

Views: 963

Posted By Neil - Colorado

Roger that! My sleeve or "race" measures...

Roger that!

My sleeve or "race" measures 30mm. Apparently, the incorrect 32mm seal that had been in place was slightly smaller than the new Reinz seal. It fully contacted the race but not as snug...

Forum: Porsche 924/944/968 Technical Forum

09-07-2017, 06:32 PM

Replies: 4

Victor Reinz Camshaft Seal ??

Views: 963

Posted By Neil - Colorado

Victor Reinz Camshaft Seal ??

Hi Guys!

I purchased a Victor Reinz Camshaft Seal from Pelican a couple of years back in order to remedy a leak the next time I did a belt change. Well, today was the day.

Preparing for...

Forum: Porsche 924/944/968 Technical Forum

08-06-2017, 08:53 AM

Replies: 6

924S Clutch Hydraulic Hose Question

Views: 1,009

Posted By Neil - Colorado

All's well. The 477... Part was the correct one....

All's well. The 477... Part was the correct one. Yes, that hose clamp is a bear, small hands and patience paid off. I went through the same pain back when I did the clutch, then when I rebuilt the...

Forum: Porsche 924/944/968 Technical Forum

07-27-2017, 11:43 AM

Replies: 6

924S Clutch Hydraulic Hose Question

Views: 1,009

Posted By Neil - Colorado

Thanks Geoman! I figured there would be...

Thanks Geoman!

I figured there would be someone who had the answer. It looks like I need the 951 number. Perhaps Porsche's year reference is based on manufacture date not model year.
Hi John, I...

Forum: Porsche 924/944/968 Technical Forum

07-26-2017, 08:45 PM

Replies: 6

924S Clutch Hydraulic Hose Question

Views: 1,009

Posted By Neil - Colorado

924S Clutch Hydraulic Hose Question

The clutch hose in my 1987 924S failed, so I purchased the FTE replacement (P/N 477-421-189A). It turns out that this part is about 4" shorter than the original, so it does not reach the rigid line...

Forum: Porsche 924/944/968 Technical Forum

11-26-2013, 02:49 PM

Replies: 46

SPEC 1987 944 dedicated track car debuts at SEMA w/ pics!

Views: 9,987

Posted By Neil - Colorado

Sorry, immediately lost interest when I saw the...

Sorry, immediately lost interest when I saw the Chevrolet engine.

Forum: Porsche 924/944/968 Technical Forum

08-14-2011, 05:13 PM

Replies: 22

924S Oil Pressure - GONE

Views: 3,620

Posted By Neil - Colorado

For now it looks like this one will be filed...

For now it looks like this one will be filed under "Fixed but Unsolved"
... unless the problem returns.

I reinstalled the old oil filter just for a test. After a run at normal operating...

Forum: Porsche 924/944/968 Technical Forum

08-09-2011, 06:31 PM

Replies: 22

924S Oil Pressure - GONE

Views: 3,620

Posted By Neil - Colorado

Sorry for the delay guys! I've been off-line...

Sorry for the delay guys!

I've been off-line and under the car;)

The 924S resumed daily driver duty on Monday (8/8/2011).
I did not find a smoking gun. Which leads me to think that I missed...

Forum: Porsche 924/944/968 Technical Forum

07-24-2011, 03:16 PM

Replies: 22

924S Oil Pressure - GONE

Views: 3,620

Posted By Neil - Colorado

Back again. I had to seriously scrub-up before...

Back again. I had to seriously scrub-up before touching the computer;)

Dropping the sump is no sweat without power steering, and by using Porsche Special Tool #VW 10-220 (made by YAKIMA).
...

Forum: Porsche 924/944/968 Technical Forum

07-22-2011, 09:17 AM

Replies: 22

924S Oil Pressure - GONE

Views: 3,620

Posted By Neil - Colorado

Hello again. Thanks for the input guys! I'm...

Hello again.

Thanks for the input guys! I'm with you on suspecting the pickup tube. Perhaps the impulse at the moment of hydrolock contributed.
Of course, I'll verify proper function of the...

Forum: Porsche 924/944/968 Technical Forum

07-21-2011, 09:17 PM

Replies: 22

924S Oil Pressure - GONE

Views: 3,620

Posted By Neil - Colorado

Gone again:mad: When I got home this evening...

Gone again:mad:

When I got home this evening I went out to take the car for a test drive and the pressure is zero again.

Apparently it lost pump prime over night (like the first time).

Any...

Forum: Porsche 924/944/968 Technical Forum

07-21-2011, 08:43 AM

Replies: 22

924S Oil Pressure - GONE

Views: 3,620

Posted By Neil - Colorado

I'm back - and so is the oil pressure. Early...

I'm back - and so is the oil pressure.

Early in the game I attempted to prime the pump by introducing oil into the filter port (you know, the typical procedure) with no luck.

Last night I...

Forum: Porsche 924/944/968 Technical Forum

07-19-2011, 07:59 AM

Replies: 22

924S Oil Pressure - GONE

Views: 3,620

Posted By Neil - Colorado

Thanks guys. John - I did pull the relief...

Thanks guys.

John - I did pull the relief valve components (old-style spring / piston / cap). The spring appears good with decent compression required to replace the cap. I will re-check to verify...

Forum: Porsche 924/944/968 Technical Forum

07-18-2011, 05:00 PM

Replies: 22

924S Oil Pressure - GONE

Views: 3,620

Posted By Neil - Colorado

924S Oil Pressure - GONE

Hello all:

Last evening I drove the car for about 45 minutes. The pressure was fine at shutdown. I noted that it was about 2.5 - 3 bar (hot engine, 90 deg F ambient). This morning there was no...

Forum: Porsche 924/944/968 Technical Forum

05-31-2011, 08:23 PM

Replies: 40

no spark cylinder #2 and #3

Views: 7,200

Posted By Neil - Colorado

I found the problem when I got the car home. ...

I found the problem when I got the car home.

The first thing I noticed was that is was only firing on one cylinder. Then, when I attempted to manually set the crank to TDC, I noticed that the cam...

Forum: Porsche 924/944/968 Technical Forum

05-26-2011, 11:15 AM

Replies: 40

no spark cylinder #2 and #3

Views: 7,200

Posted By Neil - Colorado

I do not jsut assume anything. I'll have the...

I do not jsut assume anything.

I'll have the car taken home by flatbed where I can actually work on it. I'll report back with any findings.

Thanks, Neil

Forum: Porsche 924/944/968 Technical Forum

05-25-2011, 07:38 PM

Replies: 40

no spark cylinder #2 and #3

Views: 7,200

Posted By Neil - Colorado

I'm very curious too: My car is suffering...

I'm very curious too:

My car is suffering from the identical problem right now. It has been sitting in my office parking lot for the last three nights as I attempt to diagnose (in the rain).
...

Forum: Porsche 924/944/968 Technical Forum

04-15-2011, 07:19 AM

Replies: 110

Gas fumes? Tank leaks? Read this.

Views: 50,578

Posted By Neil - Colorado

Hi John: Yes, we share the same fuel tank...

Hi John:

Yes, we share the same fuel tank (p/n 477 201 021 F).

As far as checking for leaks, first look for any stains on the sides of the tank. I remember that my tank showed stains on the...

Forum: Porsche 924/944/968 Technical Forum

04-09-2007, 06:37 PM

Replies: 110

Gas fumes? Tank leaks? Read this.

Views: 50,578

Posted By Neil - Colorado

Hey Gerard: I'll shoot you a Private Message...

Hey Gerard:

I'll shoot you a Private Message on that topic.

Neil

Forum: Porsche 924/944/968 Technical Forum

04-08-2007, 10:32 AM

Replies: 110

Gas fumes? Tank leaks? Read this.

Views: 50,578

Posted By Neil - Colorado

Gerard: It sounds like you solved the...

Gerard:
It sounds like you solved the difficult-to-access problem. At least you won't have to drop the tank again!

Jon:
I found that the later plastic tank is a no-go in our cars. The structural...

Forum: Porsche 924/944/968 Technical Forum

04-07-2007, 05:19 PM

Replies: 110

Gas fumes? Tank leaks? Read this.

Views: 50,578

Posted By Neil - Colorado

Hi Gerard: I'll update by explaining a...

Hi Gerard:

I'll update by explaining a modifiaction that I made since my last post. I had mentioned that Porsche probably should have provided a 2-way valve that releases at a lower pressure....

Forum: Porsche 924/944/968 Technical Forum

01-16-2006, 06:50 PM

Replies: 110

Gas fumes? Tank leaks? Read this.

Views: 50,578

Posted By Neil - Colorado

Granite944: If one suspects the vent line to...

Granite944:

If one suspects the vent line to the canister, or the canister itself is clogged, there is an easy way to check this. Simply disconnect the line where shown below and blow into the...

Forum: Porsche 924/944/968 Technical Forum

01-15-2006, 06:52 PM

Replies: 110

Gas fumes? Tank leaks? Read this.

Views: 50,578

Posted By Neil - Colorado

Thank you Dean924s! I would like to make a...

Thank you Dean924s!

I would like to make a comment on the removal of the "Two-Way" valve or "Overfill Limiter" as it is sometimes called.

This valve allows pressure to escape to the charcoal...

Showing results 1 to 25 of 38

Page 1 of 2

Forum Jump

All times are GMT -8. The time now is 08:37 PM.