Pelican Parts Forums - Search Results

		Pelican Parts Forums > Search Forums
Search Results

Garage

Showing results 1 to 6 of 6
Search took 0.01 seconds. Search: Posts Made By: modelguy

Forum: Porsche 911 Technical Forum

07-24-2006, 08:32 PM

Replies: 11

ignition switch problem

Views: 921

Posted By modelguy

The power wire to the WUR has almost no...

The power wire to the WUR has almost no resistance to ground, so I have to start tracing I think. The problem is that the harness goes immediately under the airbox and I can't see where it comes...

Forum: Porsche 911 Technical Forum

07-24-2006, 02:18 PM

Replies: 11

ignition switch problem

Views: 921

Posted By modelguy

I think pictures are worth 10,000 words at this...

I think pictures are worth 10,000 words at this point, especially if the wires are supposed to be easily accessible. Locations of parts you're describing would help the most, I've never dealt with...

Forum: Porsche 911 Technical Forum

07-24-2006, 11:06 AM

Replies: 11

ignition switch problem

Views: 921

Posted By modelguy

At the 14 pin connector, the upper rightmost...

At the 14 pin connector, the upper rightmost (#14) has power. The second lower pin (#3) and the upper second pin (#4) have about 9V each. The third upper pin from the left (#6) has no power. I...

Forum: Porsche 911 Technical Forum

07-21-2006, 02:29 PM

Replies: 11

ignition switch problem

Views: 921

Posted By modelguy

Ok, I retried a few things...the center (red)...

Ok, I retried a few things...the center (red) wire has power with the key in run position, none with key out. I checked all wiring and it all looks clean. Any thoughts? I really want to get this...

Forum: Porsche 911 Technical Forum

07-20-2006, 11:02 AM

Replies: 11

ignition switch problem

Views: 921

Posted By modelguy

On the three pin connector, the center wire (red)...

On the three pin connector, the center wire (red) has +12V even with the key out of the switch. That's the only red wire I see. Is the other one the wire that plugs into the spade? Is there a way...

Forum: Porsche 911 Technical Forum

07-19-2006, 06:03 PM

Replies: 11

ignition switch problem

Views: 921

Posted By modelguy

ignition switch problem

When I try to start my 77 911 it'll start up and run as long as I hold the key in the start position. As soon as I let go of the key, the engine dies. I replaced the electrical part of the switch,...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -8. The time now is 05:36 AM.