Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums
Reload this Page Search Results
Register Garage FAQ Community Calendar Today's Posts Search


Page 1 of 4 1 2 3 Next » Last »
Showing results 1 to 25 of 90
Search took 0.02 seconds. Search: Posts Made By: bmwbeemer7
Forum: Boxster & Cayman Forum 10-17-2023, 07:59 PM
Replies: 0
Views: 386
Posted By bmwbeemer7
1998 Boxter 986 leak at rear CV Axel upon hub replacement

I have a 1998 Boxster and I had to replace my passenger CV shaft along with my bearings in my hub. So I just purchased a low mileage hub and shaft. I worked on it for some time one day then the next...
Forum: 101 Projects Discussion Forum: BMW 3-Series 01-16-2018, 12:35 PM
Replies: 0
Views: 517
Posted By bmwbeemer7
1994 325i with tranny from 98 slipping

I have a 1994 325ic and i just installed a perfectly working transmission from my sons wrecked 1998 328i. Its the same transmission which verified here on Pelican before I did the switch. The only...
Forum: 101 Projects Discussion Forum: BMW 3-Series 09-25-2017, 01:53 PM
Replies: 8
Views: 1,003
Posted By bmwbeemer7
I finally got the tranny installed from the 98 to...

I finally got the tranny installed from the 98 to the 94 but the connector is different. It has the same amount of pins but different connection. Any ideas?
Forum: 101 Projects Discussion Forum: BMW 3-Series 09-25-2017, 06:17 AM
Replies: 0
Views: 490
Posted By bmwbeemer7
1994 325i with 328i transmission but different wire connector

I have a 1994 e36 and the automatic trains went out. So I had a 98 328i auto that my son wrecked. So I removed the transmission to put in my 94. Everything seems to match up but the wire connection...
Forum: 101 Projects Discussion Forum: BMW 3-Series 01-20-2017, 01:47 PM
Replies: 4
Views: 723
Posted By bmwbeemer7
I would use 2 just to be on the safe side. Also,...

I would use 2 just to be on the safe side. Also, it gives you plenty of clearance. I gotta put a transmission in my 94 325ic and I only have 2 stands but I plan on picking up 2 more before I get...
Forum: 101 Projects Discussion Forum: BMW 3-Series 10-19-2016, 02:34 PM
Replies: 4
Views: 540
Posted By bmwbeemer7
Did you make sure to remove ALL the air from the...

Did you make sure to remove ALL the air from the system since it did run hot? They are known for holding on to air after running hot and it takes a special procedure in order to remove all of it to...
Forum: 101 Projects Discussion Forum: BMW 3-Series 10-19-2016, 01:23 PM
Replies: 8
Views: 1,003
Posted By bmwbeemer7
To Luccia at Pelican Parts,,,,, I just compared...

To Luccia at Pelican Parts,,,,, I just compared the vins on Real OEM and they are the same. That s a LIFESAVOR!! Thank you very very much as that is exactly what I needed to know.
Forum: 101 Projects Discussion Forum: BMW 3-Series 10-19-2016, 01:11 PM
Replies: 8
Views: 1,003
Posted By bmwbeemer7
I will definitely do that. I have a little time...

I will definitely do that. I have a little time to play with in the meantime as I'm purchasing an engine crane next month. Currently, I'm just taking my time unbolting the setup in the 98 till I have...
Forum: 101 Projects Discussion Forum: BMW 3-Series 10-18-2016, 06:36 AM
Replies: 8
Views: 1,003
Posted By bmwbeemer7
Thanks. I was thinking the same too. I would love...

Thanks. I was thinking the same too. I would love to just change the transmission but If I have to change the entire setup for compatibility issues, I'll do so.
Forum: 101 Projects Discussion Forum: BMW 3-Series 10-15-2016, 01:35 PM
Replies: 8
Views: 1,003
Posted By bmwbeemer7
Will 1998 e36 vert engine/auto trans fit directly in a 1994 e36 vert?

I have a (black)1994 BMW e36 vert with an automatic trans which the reverse has been slipping for the past year or so. My son has a (red)1998 e36 very with an automatic trans that he wrecked a few...
Forum: 101 Projects Discussion Forum: BMW 3-Series 06-26-2016, 09:01 AM
Replies: 1
Views: 365
Posted By bmwbeemer7
Will 98 E36 auto trans fit in 94 auto e36

I have a 1994 E36 V6 that I've had for 12 years with an automatic transmission that has a bad reverse and my son just happen to have a 1998 e36 V6 with an automatic trans that he wrecked last month....
Forum: 101 Projects Discussion Forum: BMW 3-Series 01-14-2015, 04:32 PM
Replies: 0
Views: 446
Posted By bmwbeemer7
E36 vert custom trunk?? Anyone ever seen one before?

I have a 1994 325ic. I added this trunk a couple years ago. I removed it from a car from Pull A Part in Augusta GA. I have done a lot of internet searching and can not find any info on it or who made...
Forum: Porsche 924/944/968 Technical Forum 10-22-2013, 12:27 PM
Replies: 19
Views: 2,579
Posted By bmwbeemer7
FIRST OF ALL, I WANT TO SAY THANK YOU TO EVERYONE...

FIRST OF ALL, I WANT TO SAY THANK YOU TO EVERYONE HERE FOR ALL YOUR COMMENTS AND HELP!! I finally got it finished today. Well, I did have to go ahead and get the passenger side brake caliper too...
Forum: Porsche 924/944/968 Technical Forum 10-15-2013, 04:34 AM
Replies: 19
Views: 2,579
Posted By bmwbeemer7
Ok. I spent all day Sunday and half of Monday...

Ok. I spent all day Sunday and half of Monday trying to bleed the clutch. I have been keeping the MC reservoir full of fluid, my hose connected to the clutch slave bleeder screw and bleeding myself...
Forum: Porsche 924/944/968 Technical Forum 10-10-2013, 07:50 PM
Replies: 19
Views: 2,579
Posted By bmwbeemer7
Thanks John. I'm going to pick up a Mighty Vac...

Thanks John. I'm going to pick up a Mighty Vac and try it tomorrow and let you know how it goes. I'm soooo ready to drive it. This is my first 924S I've owned a 79 1924, 84 944, and 79 928. I'm so...
Forum: Porsche 924/944/968 Technical Forum 10-10-2013, 05:11 PM
Replies: 19
Views: 2,579
Posted By bmwbeemer7
Turned out I had a bad clutch master cylinder....

Turned out I had a bad clutch master cylinder. Well, I just installed it and I'm ready to bleed. The clutch just flips hard to the floor at this point. What is the easiest way to bleed the clutch?...
Forum: Porsche 924/944/968 Technical Forum 09-26-2013, 10:35 AM
Replies: 19
Views: 2,579
Posted By bmwbeemer7
Can anyone tell me how to bleed the clutch?

Can anyone tell me how to bleed the clutch?
Forum: Porsche 924/944/968 Technical Forum 09-26-2013, 10:30 AM
Replies: 6
Views: 736
Posted By bmwbeemer7
Can anyone tell me how to bleed the clutch?

Can anyone tell me how to bleed the clutch?
Forum: Porsche 924/944/968 Technical Forum 09-24-2013, 12:56 PM
Replies: 19
Views: 2,579
Posted By bmwbeemer7
I found one at Carquest for $80 and ordered it....

I found one at Carquest for $80 and ordered it. It will be here on Thursday. Once I do install it, do I just bleed the system out and the clutch would be affected? I'm sorry but I have not worked on...
Forum: Porsche 924/944/968 Technical Forum 09-24-2013, 11:43 AM
Replies: 19
Views: 2,579
Posted By bmwbeemer7
Just remove front driver side wheel and brake...

Just remove front driver side wheel and brake fluid is leaking directly from caliber. I'm sure I'm gonna have to replace it but I'm not seeing any fluid leaking from any other source but I'm gonna...
Forum: Porsche 924/944/968 Technical Forum 09-24-2013, 05:04 AM
Replies: 19
Views: 2,579
Posted By bmwbeemer7
I'm looking right now. I see some folks...

I'm looking right now. I see some folks mentioning something about a cable in that area.
Forum: Porsche 924/944/968 Technical Forum 09-24-2013, 04:48 AM
Replies: 19
Views: 2,579
Posted By bmwbeemer7
Porsche 924s clutch goes to floor

Just purchased a 1987 924S and the clutch just drops down to the floor with a thump. The guy i bought it from said the clutch is good but when his wife was driving it, it sprung a leak. I did notice...
Forum: 101 Projects Discussion Forum: BMW 3-Series 09-03-2011, 11:21 AM
Replies: 3
Views: 798
Posted By bmwbeemer7
I thought I had the same problem. I have a 94...

I thought I had the same problem. I have a 94 325ic and I went to pick up my son from school and the top was closed and I had the ac on. At first I had my windows up, but as my son got ready to get...
Forum: 101 Projects Discussion Forum: BMW 3-Series 09-03-2011, 03:54 AM
Replies: 2
Views: 599
Posted By bmwbeemer7
I still have the same problem. I think it is a...

I still have the same problem. I think it is a sensor but I don't know where they are located for the top. Good luck and let me know if you come up with anything. Thanks
Forum: Porsche 928 Technical Forum 08-15-2011, 02:05 PM
Replies: 12
Views: 3,716
Posted By bmwbeemer7
I ordered a new pump from Ebay. It is a seller on...

I ordered a new pump from Ebay. It is a seller on there selling them for $49.99 with free shipping at Ebay item number 220558304985. I installed it and it works great. I no longer hear that loud...
Showing results 1 to 25 of 90
Page 1 of 4 1 2 3 Next » Last »

 
Forum Jump

All times are GMT -8. The time now is 11:47 PM.

Contact Us - Pelican Parts Catalog for Porsche, BMW, Mercedes-Benz, MINI and More - Archive - Privacy Statement - Terms of Service - Top

 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.