Pelican Parts Forums - Search Results

		Pelican Parts Forums > Search Forums
Search Results

Garage

Showing results 1 to 20 of 20
Search took 0.01 seconds. Search: Posts Made By: Grun_RS

Forum: Porsche 924/944/968 Used Parts For Sale & Wanted

04-01-2015, 03:38 PM

Replies: 0

FS: 968 Factory Exhaust - Cat-Back

Views: 1,030

Posted By Grun_RS

FS: 968 Factory Exhaust - Cat-Back

Have an exhaust system off a 94 968 that's in good condition. Was removed from service at 75K miles. Includes central resonator, muffler and tail pipe, all in one unit. Picture available soon.
Local...

Forum: Porsche 924/944/968 Technical Forum

09-06-2010, 10:14 AM

Replies: 4

968 - Side Mirror Replacement

Views: 1,954

Posted By Grun_RS

Thanks... I found there's an access hole on...

Thanks...

I found there's an access hole on the under-side of the housing for a screwdriver. The cam-lock ring makes mirror replacement fairly easy...

Forum: Porsche 924/944/968 Technical Forum

09-04-2010, 11:16 PM

Replies: 4

968 - Side Mirror Replacement

Views: 1,954

Posted By Grun_RS

968 - Side Mirror Replacement

While pulling out of a driveway the other day my side [glass] mirror decided to part company and it shattered in the street. Needless to say I'll be replacing the glass mirror soon.

Are there any...

Forum: Porsche 924/944/968 Used Parts For Sale & Wanted

07-18-2010, 01:47 PM

Replies: 0

WTB - 968 Sill Cover, L/S

Views: 263

Posted By Grun_RS

WTB - 968 Sill Cover, L/S

Looking for a sill cover for a 94 968, [left side]. P/N: 944.559.173.00

The sill cover is the plastic/composite piece that's below the drivers door just forward of the rear wheel.

If you happen...

Forum: Porsche 924/944/968 Technical Forum

07-18-2010, 01:22 PM

Replies: 9

968 Sunroof Removal - How to?

Views: 5,073

Posted By Grun_RS

When working correctly you should be able to see...

When working correctly you should be able to see the arms retract. It's confusing to some - the switch works the opposite when the ignition key in the first position...

You can also move the arms...

Forum: Porsche 924/944/968 Technical Forum

07-18-2010, 01:18 PM

Replies: 9

968 Sunroof Removal - How to?

Views: 5,073

Posted By Grun_RS

Another Tip: When the arms retract from the...

Another Tip:
When the arms retract from the panel, they don't need to go all the way to the mechanical stop.

If the retract micro-switch is out of adjustment and the arms hit the mechanical...

Forum: Porsche 924/944/968 Technical Forum

07-18-2010, 01:08 PM

Replies: 42

Another no start.... Not the DME relay

Views: 3,928

Posted By Grun_RS

Is the 36psi fuel pressure specifically for a...

Is the 36psi fuel pressure specifically for a 944; even still that seems low? The 56psi I mentioned earlier is right out of the 968 spec. book.
If it cuts-off quickly I'd suspect either the ignition...

Forum: Porsche 924/944/968 Used Parts For Sale & Wanted

07-18-2010, 12:48 PM

Replies: 4

968 parts

Views: 651

Posted By Grun_RS

The 68 had 2 belly pans, one under the radiator...

The 68 had 2 belly pans, one under the radiator and one near the starter - which do you have [or both]?
Also, are there any body parts left-over; a sill cover perhaps? The sill cover is the...

Forum: Porsche 924/944/968 Technical Forum

07-05-2010, 08:20 PM

Replies: 42

Another no start.... Not the DME relay

Views: 3,928

Posted By Grun_RS

Not sure what the thread is on the 44 - on the...

Not sure what the thread is on the 44 - on the 968 it's 12 x 1.5mm. Unfortunately the proper adapters are only available in a master test kit, typically used by dealers. I checked with Porsche & VW...

Forum: Porsche 924/944/968 Technical Forum

07-03-2010, 08:56 PM

Replies: 6

Clutch depresses intermittently

Views: 614

Posted By Grun_RS

Not sure if this is common knowledge, but make...

Not sure if this is common knowledge, but make sure to raise the aft end [must be higher than the front ] while bleeding...

Forum: Porsche 924/944/968 Technical Forum

07-03-2010, 08:48 PM

Replies: 42

Another no start.... Not the DME relay

Views: 3,928

Posted By Grun_RS

I see you checked for fuel. Did you check the...

I see you checked for fuel. Did you check the actual pressure, it should be ~56psi +/- 2. If it's low, the pressure regulator may be tired.

If the AC is activated the fans would come on. If not,...

Forum: Porsche 924/944/968 Technical Forum

03-24-2010, 08:26 PM

Replies: 10

Did I damage my newly polished crank?

Views: 1,920

Posted By Grun_RS

I hate to say it, but when used correctly a...

I hate to say it, but when used correctly a micrometer shouldn't leave any marks/scratches.

Without pictures I'd guess the scratches are minor and hopefully there are no high spots. If you have...

Forum: Porsche 924/944/968 Technical Forum

03-23-2010, 10:07 PM

Replies: 4

Coil Resistance Test

Views: 3,237

Posted By Grun_RS

Ideally when checking resistance it's best to...

Ideally when checking resistance it's best to isolate the component. Perhaps get a known good coil and compare the resistance. Also, inspect the distributor cap and rotor for carbon tracks or cracked...

Forum: Porsche 924/944/968 Used Parts For Sale & Wanted

12-31-2009, 10:53 AM

Replies: 11

Saratoga Top

Views: 1,113

Posted By Grun_RS

@ ASA; what say you? Is the panel still...

@ ASA; what say you? Is the panel still available? Any chance of taking more pics?

Does anyone know the part number for the seal? In the 1st pic the seal looks ragged..

Forum: Porsche 924/944/968 Used Parts For Sale & Wanted

12-21-2009, 09:07 PM

Replies: 11

Saratoga Top

Views: 1,113

Posted By Grun_RS

This should also fit a 968... Any chance you...

This should also fit a 968...

Any chance you could take a pic of the top surface? And perhaps of the seal along the side? I'm not sure if a OEM seal would fit if it needed replacement.

Forum: Porsche 924/944/968 Technical Forum

12-03-2009, 08:43 PM

Replies: 18

Cup wheels explained by noted 964 expert Adrian Streather

Views: 6,463

Posted By Grun_RS

Interesting, thanks 4 posting...

Interesting, thanks 4 posting...

Forum: Porsche 924/944/968 Used Parts For Sale & Wanted

12-03-2009, 08:34 PM

Replies: 15

WTB: Cup Wheels 17"

Views: 2,454

Posted By Grun_RS

RB; Nice set... I ended up buying a set...

RB; Nice set...

I ended up buying a set from Jim [Capt. Squid]. However, I'd like to pick up one 7.5x17 to complete my original set.
If anyone has 1 front wheel, let me know...

Forum: Porsche 924/944/968 Used Parts For Sale & Wanted

11-05-2009, 12:38 PM

Replies: 15

WTB: Cup Wheels 17"

Views: 2,454

Posted By Grun_RS

@tom; thanks, but I'm looking for 7.5" - the 7"...

@tom; thanks, but I'm looking for 7.5" - the 7" is fairly common and can be had for ~$200/ea.

@dp951; I only need 1 of each, [front & rear]. Can you please list the offsets.

My car has been...

Forum: Porsche 924/944/968 Used Parts For Sale & Wanted

11-04-2009, 11:45 AM

Replies: 15

WTB: Cup Wheels 17"

Views: 2,454

Posted By Grun_RS

I'm in S. California @Litespeeds: nice, is...

I'm in S. California

@Litespeeds: nice, is that for local sale only or are you willing to ship?

Forum: Porsche 924/944/968 Used Parts For Sale & Wanted

11-03-2009, 10:01 PM

Replies: 15

WTB: Cup Wheels 17"

Views: 2,454

Posted By Grun_RS

WTB: Cup Wheels 17"

I know this is a long-shot, but I'm looking for the following factory wheels:

7.5 x 17 Cup wheel [ET 65] - P/N: 993.362.124.05

9 x 17 Cup Wheel [ET 55] - P/N: 993.362.128.00

I've check all...

Showing results 1 to 20 of 20

Forum Jump

All times are GMT -8. The time now is 05:14 PM.