Pelican Parts Forums - Search Results

		Pelican Parts Forums > Search Forums
Search Results

Garage

Showing results 1 to 13 of 13
Search took 0.01 seconds. Search: Posts Made By: Steve J.

Forum: Porsche 911 Technical Forum

06-27-2016, 01:48 PM

Replies: 25

911 AC Stress Test results

Views: 2,379

Posted By Steve J.

My system is converted to 134a, and the hose...

My system is converted to 134a, and the hose replacement set really helped. I'm happier with the fan on the front and not the back. If I want more AC, I will put a larger condenser in front with a...

Forum: Porsche 911 Technical Forum

06-23-2016, 03:51 PM

Replies: 25

911 AC Stress Test results

Views: 2,379

Posted By Steve J.

911 AC Stress Test results

Over a few years I have upgraded my 86 Carrera AC with RennAir components. Over time I have installed the front condenser, evaporator, barrier hoses, Sanden compressor and pro-cooler receiver/dryer;...

Forum: 911 Engine Rebuilding Forum

11-06-2015, 10:30 PM

Replies: 39

964 cam timing in a 3.2

Views: 7,388

Posted By Steve J.

I've had a nice result from WebCam 20/21 set at...

I've had a nice result from WebCam 20/21 set at 2.2. I've dynoed at 275hp/260tqin my 3.4 with good drivability and passing California smog checks.

Forum: Porsche 911 Technical Forum

07-22-2015, 04:20 PM

Replies: 24

Does Rennaire upgrade work?

Views: 2,831

Posted By Steve J.

I have Rennair's products in my triple black 86...

I have Rennair's products in my triple black 86 carrera and I'm very satisfied. Have spoken with them on the phone and they were very nice and helpful. I have the desert front condenser which made...

Forum: Porsche 911 Technical Forum

02-23-2015, 12:05 AM

Replies: 50

New Los Angeles Porsche shop -- from one of our own

Views: 8,710

Posted By Steve J.

They took my 86 Carrera in for rear arms. Came...

They took my 86 Carrera in for rear arms. Came out great, and the chassis setup is spot on! Thanks guys.

Forum: 911 Engine Rebuilding Forum

03-28-2014, 10:05 AM

Replies: 54

Crappy Dyno Results on 3.4L Rebuild

Views: 8,391

Posted By Steve J.

I don't think the problem is your system's...

I don't think the problem is your system's ability to flow enough fuel because your peak power fuel is fine, which is at the highest flow rate. The 4 to 5 K rev band is your problem area, which has...

Forum: 911 Engine Rebuilding Forum

03-26-2014, 04:09 PM

Replies: 54

Crappy Dyno Results on 3.4L Rebuild

Views: 8,391

Posted By Steve J.

I would question the builder about cam timing,...

I would question the builder about cam timing, and ask for a recheck. Did you remove the O2 sensor and put the probe into the hole for the O2 sensor to check the AF ratio at wide open throttle? If...

Forum: Porsche 911 Technical Forum

11-20-2013, 10:50 AM

Replies: 6

Porsche 911 rear trunk latch adjustment

Views: 1,589

Posted By Steve J.

Try rotating the rubber grommets on each corner...

Try rotating the rubber grommets on each corner of the lid to lengthen the grommet.

Forum: Porsche 911 Technical Forum

11-20-2013, 10:10 AM

Replies: 24

Suspension upgrades

Views: 2,762

Posted By Steve J.

Regarding the camber adjustments, I have the...

Regarding the camber adjustments, I have the offset lower ball joints from Elephant on my 86 Carrera and a tower brace, along with some of the other mods previously mentioned, including the turbo rod...

Forum: Porsche 911 Technical Forum

03-23-2012, 10:27 AM

Replies: 143

Slippery AC Slope

Views: 10,162

Posted By Steve J.

I've had a good result with the Rennair stuff,...

I've had a good result with the Rennair stuff, including the evaporator, hoses, and especially the front "desert duty condenser", which I highly recommend.

Forum: Porsche 911 Technical Forum

12-06-2011, 11:39 PM

Replies: 27

Better daily driver 986 2.7 boxster vs 911 3.2

Views: 6,896

Posted By Steve J.

I have driven my 86 Carrera as a daily driver for...

I have driven my 86 Carrera as a daily driver for 120,000 miles, and love it. I have upgraded the AC with Rennaire front condenser, barrier hoses, porcooler, and serpentine type evaporator. I live...

Forum: 911 Engine Rebuilding Forum

11-21-2011, 12:31 AM

Replies: 6

Exhaust Crossover Pipe Thermal Wrap

Views: 1,978

Posted By Steve J.

I recently had a thermal barrier ceramic coating...

I recently had a thermal barrier ceramic coating done on the inside and outside of the crossover pipe. I think there's a lot of radiant heat from there on the engine as well as the tranny.

Forum: 911 Engine Rebuilding Forum

10-26-2010, 02:13 AM

Replies: 6

Engine Dyno in Southern California

Views: 1,805

Posted By Steve J.

HK motorsports in Van Nuys has a dyno jet. ...

HK motorsports in Van Nuys has a dyno jet. Harry, the owner, is a decent person, as well. I have known him more than 20 years.

Showing results 1 to 13 of 13

Forum Jump

All times are GMT -8. The time now is 12:04 PM.