Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums
Reload this Page Search Results
Register Garage FAQ Community Calendar Today's Posts Search


Page 1 of 3 1 2 3 Next »
Showing results 1 to 25 of 74
Search took 0.01 seconds. Search: Posts Made By: boxsterg
Forum: Porsche 911 Used Parts For Sale & Wanted 02-16-2017, 07:21 PM
Replies: 2
Views: 1,713
Posted By boxsterg
Durametric for sale

For sale one Durametric Enthusiast kit. I have registered one VIN of the three allowed leaving it with two free. For years:

1996-1998 Porsche 993
1997-2004 Porsche Boxster (986)
2005-2012...
Forum: Boxster & Cayman Forum 05-23-2015, 11:08 PM
Replies: 3
Views: 423
Posted By boxsterg
Clutch Slave

Does anyone have a diagram of the order the internal parts go on the slave. I don't see any type of snap ring or keeper to re-assemble the new one I just blew out.
Forum: Boxster & Cayman Forum 05-23-2015, 12:41 PM
Replies: 3
Views: 423
Posted By boxsterg
Are you familiar with the fitting type of the...

Are you familiar with the fitting type of the slave hose exiting the reservoir?
Forum: Boxster & Cayman Forum 05-23-2015, 12:14 PM
Replies: 3
Views: 423
Posted By boxsterg
Clutch Bleeding

Hi Everyone:
I replaced clutch slave on 2000 2.7 Boxster. Then pumped pressure to 22 psi. with clutch pedal to floor. Let air out of bleeder valve. Pulled clutch up by hand. Clutch would not go...
Forum: Boxster & Cayman Forum 04-30-2014, 07:12 PM
Replies: 10
Views: 2,185
Posted By boxsterg
I'm pretty sure the noise is the rear axle cv...

I'm pretty sure the noise is the rear axle cv joint. I'll tackle it next time I have garage access. Probably replace wheel bearings also.
Forum: Boxster & Cayman Forum 04-30-2014, 07:01 PM
Replies: 1
Views: 668
Posted By boxsterg
I found them. On a 2000 2.7 one is clearly...

I found them. On a 2000 2.7 one is clearly visible after removing the interior panel it's directly behind the drivers seat. The other is hiding behind the aos. I also replaced the small accordian...
Forum: Porsche Cayenne & Macan Forum 02-24-2014, 04:23 PM
Replies: 1
Views: 529
Posted By boxsterg
Cam position sensor help

I'm having trouble locating my cam position sensor. I have a Bentley which states I should be able to access them from the top of the engine, left front and right rear. I can't see either of them...
Forum: Boxster & Cayman Forum 02-09-2014, 06:49 PM
Replies: 1
Views: 668
Posted By boxsterg
camshaft position sensor question

I have a 2000 Boxster 2.7 and I'm trying to locate the cam position sensors. Bentley says I should access from top however I'm not seeing them. The pic on this site is such an extreme close up that...
Forum: Boxster & Cayman Forum 11-15-2013, 09:48 AM
Replies: 2
Views: 1,116
Posted By boxsterg
Will a durametric short test help to identify...

Will a durametric short test help to identify some of these problems?
Or are there any other tests I can do to help diagnose with durametric?
Is there a toggle test for the acutator?
Thanks,
Garry
Forum: Boxster & Cayman Forum 11-13-2013, 06:59 PM
Replies: 2
Views: 1,116
Posted By boxsterg
2000 Boxster/ rough idle and these codes

Hi everyone, I'm experiencing a rough idle on my boxster. I hooked up the Durametric and I have the following codes:

P code 174

P code 62

P code 65 cyl 3 misfire

P code 63 cyl 1 misfire
Forum: Boxster & Cayman Forum 10-02-2013, 11:20 AM
Replies: 11
Views: 1,958
Posted By boxsterg
Okay finally replaced the CPS and it solved my...

Okay finally replaced the CPS and it solved my hot start issue. Now I have rattles and vent problems to chase for a while. Thanks for all who replied.
Forum: Boxster & Cayman Forum 09-17-2013, 11:18 AM
Replies: 2
Views: 1,087
Posted By boxsterg
Mine did that and I replace the tensioners and it...

Mine did that and I replace the tensioners and it stopped the rattle. I also replaced a less expensive part at the same time a smaller part that contained a spring. I'll have to dig through...
Forum: Boxster & Cayman Forum 09-07-2013, 07:47 PM
Replies: 11
Views: 1,958
Posted By boxsterg
Hey Randy where does the other end of the vent...

Hey Randy where does the other end of the vent line go? The larger line on the bottom of the intake left side. Also was it you that I read said you could get that line off without removing the...
Forum: Boxster & Cayman Forum 09-02-2013, 05:56 PM
Replies: 11
Views: 1,958
Posted By boxsterg
Purge

Thanks Randy I'll check it out.
Garry
Forum: Boxster & Cayman Forum 08-31-2013, 09:10 PM
Replies: 11
Views: 1,958
Posted By boxsterg
no hot start

How do I check the purge valve? Mine is acting like a vac. leak. Also Randy mine does hunt A bit just about 100 or so rpm's. Also how do I test the cps.
Thanks.
Forum: Boxster & Cayman Forum 08-27-2013, 09:18 PM
Replies: 11
Views: 1,958
Posted By boxsterg
Update. Last night I started it, erased the...

Update. Last night I started it, erased the codes, and let it idle till it died. 15 min or so. Reached 180 degrees. Then flashed an immobilizer code on the durametric. No other codes yet. I...
Forum: Boxster & Cayman Forum 08-25-2013, 09:19 PM
Replies: 11
Views: 1,958
Posted By boxsterg
Thanks, I've since noticed it will start when...

Thanks, I've since noticed it will start when cold and run ok. Will not start when at operating temp. Would this eliminate the crank sensor? Does it imply something else?
Thanks again.
Forum: Boxster & Cayman Forum 08-23-2013, 05:36 PM
Replies: 11
Views: 1,958
Posted By boxsterg
Starting issue. Cranks does not start.

Hi, I could use some help. My Boxster left me stranded at a light. Would crank but not start. After checking fuel pump fuse was ok I had it towed home. I jumpered pins 30 and 87 on fuel pump...
Forum: Boxster & Cayman Forum 08-10-2013, 02:52 PM
Replies: 5
Views: 938
Posted By boxsterg
convertible top

Hi guys, my symptoms were, a broken cable tip, on right side, popped out of slider on right side, and broken ball joint on left side. Popped in slider, replaced cable and ball joint and now works...
Forum: Boxster & Cayman Forum 07-28-2013, 02:42 PM
Replies: 5
Views: 938
Posted By boxsterg
Unhappy top problem clamshell raises on left only

Hi, yesterday I went to put my top down and the top went back 6in or so and the clamshell only raised on the drivers (left) side. I attempted to lift the other side by hand to see if I could unbind...
Forum: Boxster & Cayman Forum 08-21-2012, 04:45 PM
Replies: 10
Views: 2,185
Posted By boxsterg
I'll check the brake calipers and the bumber...

I'll check the brake calipers and the bumber struts next time I'm under there. Sounds too solid to be exhaust. Yes I've replaced the drop links with heavy duty ones. And yes shock tower bolts are...
Forum: Boxster & Cayman Forum 08-13-2012, 08:43 PM
Replies: 10
Views: 2,185
Posted By boxsterg
Deep metalic rattle

Hi Gang,
Ive had an ongoing metalic rattle in the rear of my 986. Originally thought bad strut or mount. Replaced all struts mounts and bearings. Handles better, still rattles. Thought maybe bad...
Forum: Boxster & Cayman Forum 08-08-2012, 09:06 PM
Replies: 17
Views: 5,268
Posted By boxsterg
Thanks for your reply. never would have even...

Thanks for your reply. never would have even thought of buying a non-Porsche cap except it was listed as on sale oem and had a pic of a blue cap with the proper 04 ending pn and came in a ziplock...
Forum: Boxster & Cayman Forum 08-04-2012, 12:33 PM
Replies: 17
Views: 5,268
Posted By boxsterg
coolant cap question

I ordered and received a coolant cap for my 986 from another site. It's picture was blue and stated genuine Porsche. The part no shown was 996 106 447 04. Upon arrival: the cap is black, does not...
Forum: Boxster & Cayman Forum 05-24-2012, 04:32 PM
Replies: 4
Views: 1,111
Posted By boxsterg
resistor

Yeah was hoping someone has some replacement resistor info, as it is my daily driver and I prefer to have a part on hand when I replace the old one, so I'm not stuck riding my bike or my dying truck....
Showing results 1 to 25 of 74
Page 1 of 3 1 2 3 Next »

 
Forum Jump

All times are GMT -8. The time now is 01:22 PM.

Contact Us - Pelican Parts Catalog for Porsche, BMW, Mercedes-Benz, MINI and More - Archive - Privacy Statement - Terms of Service - Top

 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.