|
|
|
|
| Author |
|
|
Guest
Posts: n/a
|
I got a code for a camshaft sensor error, but I've replaced it several times and the code comes back post vehicle stalling. Here is what is weird. I disconnected the wires to the camshaft sensor and the vehicle still runs and starts no problem. How could this be?
__________________ This post was auto-generated based upon a question asked on our tech article page here: Pelican Technical Article: BMW Camshaft Position Sensor Replacement |
||
06-04-2013, 05:13 AM
|
|
|
Moderator
Join Date: Jul 2012
Location: New England
Posts: 3,189
|
If the sensor has been replaced and the code is still present, I would check the wiring and the sensor signal at the DME.
The engine may start without a camshaft sensor, it will sync off the crankshaft position sensor. - Nick |
||
|
06-04-2013, 05:13 AM
|
|
