Torch cut parts kit? You rebuilding an MG34 into a semi auto? Pretty cool. Pics when you are done, please.
I'd still use a grinder to square up that end - - either bench grinder or a hand grinder clamped down to a bench or drill press as suggested above. The drill press suggestion is pretty good if you have one. The loads are low when grinding, so a drill press should be more than adequate.
I'm guessing that's the bolt. Thinking this through, I assume you will weld another piece to that end, and then you'll have to smooth your weld. The weld will need to be machined round and the bolt accurately spaced then. You might also be able to do that with a file and lots of patience - - or find a guy with a lathe. [emoji4]
Sent from my ONEPLUS A6013 using Tapatalk
|