|
Registered
Join Date: Dec 2011
Location: Virginia Beach, VA
Posts: 526
|
I seem to remember a post on the forums where someone mounted one end of the spring in a bench vice and pulled on the other end while inserting washers between the coils one at a time. I would think you would need to tape the washers in place to prevent them falling out after each pull. Then after there are several washers in place (the spring is lengthened), it can be installed. Remove the washers after installation.
I have never done this job, but this method makes sense.
__________________
-Dennis
1977 930 Slant, MS3 EFI, Carrera intake, Twin plug, Powerhaus headers, Magnaflow muffler, Garretson intercooler, GTX3071R
|