[piperpilotduane]

I think I read that the clutch should be 7 to 8 MM total thickness. I used a open end wrench to check mine a 2 years ago and had to replace mine. I think mine was down to 6MM. I believe I would at least replace my clutch disk and throw out bearing anyway. It will save you hassle in the long run. I have only bought one pressure plate in the 10 or so times I've changed porsche/VW clutches. It had rust pits in the plate. I use steel wool to polish the plate and flywheel after I clean them with solvent. Good Luck!

------------------
Duane
'76 912E, '73 914,
& '76 VW BUS (ALL 2.0L)