[AirJose]

MikeP: If you want to save a lot, find a specialty shop in the area where they do clutches and pressure plates. To redo the disk and check and resurface the clutch pressure plate should be comparatively inexpensive. Don't put the engine back without at least getting these parts checked. Remove the throwout bearing and lubricate the ball area where it mounts (you will see where the old hi-temp grease is located) you will need preferably an allen wrench to replace the throwout bearing. But if you do not know the condition of the throwout bearing, or what to check, get a new german one. Follow all the previous emails they are guiding you right. Best of luck.