[dogberry]

Hi again,

I was trying to change the points on my 914 when I (being the stupid idiot I am) dropped the screw for the points into somewhere never to be seen again. It will never be found and I have given up. So I went to my basement as found an old screw that fit the old one's spot. It went in nicely and I now have new points installed. Next on my list was the capacitor/condenser. I got that screw off (without loosing it) but the wire that goes from the bottom of the condenser/capacitor goes to some far off place that I cannot get at without taking apart the entire engine. Or so it seems. So Instead I stripped the wire on the new condenser and on the wire going nowhere so that it connected the old wire to the new condenser. I know that should solder it but I got lazy. After all that when I was putting the distributor rotor on (aka: spinny thingy) I accidently turned the distributor. And I have no clue where it was at either. So, now my question is how to get it to run again as it will not run when everything is put back together. I know this is long and I am inexperienced but please help me out. Thanks a ton, Jon