|
Registered
Join Date: Nov 2001
Location: Melbourne, Florida
Posts: 431
|
If you are pulling the sensors for a clutch job, the bracket & the remaining sensor will come away from the pivot dowel in the block when you pull the bellhousing away. Does that make sense? In other words, the sensor and bracket are now free to move with the bellhousing.
Also for resetting the sensor gap, I did something a little different than the washer setup on the clutch job I just did. Once I had the flywheel mounted, I slipped a sensor back into the bracket with the bellhousing still off. Then while under the car, I could use a feeler gauge and very easily adjust the sensor gap (the bracket bolts are very accessable from underneath with the bellhousing removed). Once set, I pulled the sensor back out and continued the re-assembly process.
Rob
|