Quote:
Originally Posted by fred cook
I think I see your problem.You can't run the same power wire (from switch) to feed both the high and low relays. The yellow wire from the switch should only go to the low beam relay and the white wire from the switch should only feed the high beam relay. Everything else looks to be ok. It would help to know what year your car happens to be!
|
I'm currently running the feed wires as you describe. Note that the white wire is spliced to blue, so you see the blue wire connecting on top. Car is 1979 911 SC.
Tim's questions:
I can move the white wire from 8 over to 7. Theoretically they should be the same due to the internal bus. But I'm happy to try anything.
Do you have the internal bus for 5 & 6? My board isn't marked with one, which is why I put in the copper jumper.
As noted above, I have the colors at the bottom of the panel looking correct.
Update: I might be having the issue because I only have mounting screws at the ends of the fuse panel, and not in the middle spots in the panel. It might be relying on a middle screw for ground for the relays. I haven't had those middle screws in years. Does anyone know what spec they are offhand? I can always pull out one of the end ones and take it to the store to match, assuming they are identical.