[ToySnakePMC]

27mm hollow Sway A Ways were lubed up and set the new Rebel Racing spring plates to approx 24.3 degrees. Used some new, long Ace Hardware hex head bolts and spacers to get the new spring plate covers started. My original 4-bolt covers looked fine on the exterior view, but were heavily pitted inside where the rubber bushing had been pushing on it for the last 46+ years… If you’re going to rebuild your original old suspension, go ahead and order all the new little pieces & parts. You won’t be disappointed.









Rear brake calipers needed a fresh look on life so I popped out the pistons, cleaned everything, are reassembled with new ATE parts and hydraulic assembly lube. This is great stuff and recommended if you’re not immediately putting brake fluid back into the caliper. I probably used 4 teaspoons out of this 8 oz container…