[LBEEMING]

First off, thanks to everyone on here for the 100's of topics I read through to educate myself.

I was chasing a low idle and an erratic cold start. Replacing mostly everything and not fixing any intake leaks. Why??? Well, I just couldnt find any. Used a home made smoke gun, sprayed starter fluid and used a stethoscope to try and hear leaks. Couldnt find anything.

I did have two clues however, that I was running some leaks. Firstly the vacuum reading was only 13 inches. *** Frans Garage, she actually has the same reading as I did, but this was before she rebuilt. From reading on this forum, I found an article that stated a very healthy and rebuilt engine should run ~ 17 inches.

Secondly when removing the oil cap, my engine rpm did not drop significantly or at all.

How did I fix this leak, I just rebuilt the entire intake system.... I had enough and just thought, stuff it, ill put the effort in.

All new intake gaskets, hoses and o rings.

Now I am reading 17 inches of vacuum and removing the oil cap yields a significant drop in rpm.

Now I have to adjust the idle and CO as she is running slightly richer now.

I believe most of the leakage was from the intake gaskets, and why its hard to diagnose this sometimes, is the air flow from the fan and engine shield. Just my thoughts.

Thanks again for everyone's help, and hope that someone might just take the plunge and rebuild the intake instead of pulling their hair out for months.