|
Changed Belts - Now starter won't engage
Yep, I FINALLY found the time and mental energy to change my camshaft/balance shaft belts (along with the P/S and A/C belts).
After working through the Clark's garage instructions and occassionally referencing the Haynes manual, I've got her put back together. Unfortunately, when I tried to start the lass, the starter sounds like it is spinning but not engaging.
When I get back home tonight I plan to remove and re-install the starter but I was hoping someone here could steer my efforts.
Any ideas?
Kind Regards,
DL 
__________________
84 944 5spd
Maint. & Fixes made thanks to the help received on this board:
Rear Hatch Pins, Oil Change, Dash Cover Installation, New Rear Seat, New O2 Sensor, New Ignition Switch, New Fuel Pump Relay, Rear Light Assembly Reseal, Instrument Panel Short Circuit, New Speedo Cable, New Timing belts and Starter.
|