|
wswartzwel says:
"If you wanna cut corners.... remove bolt 1 reach through the hole and grease the needle bearing that is pressed into the housing.... reinstall bolt.... then remove bolt with jam nut #2 grease that side the same way....reinstall that bolt... then torque the right side, then tighten the left side till there is no play, but the housing will move up and down freely ( this is all done with the rear wheel and torque arm removed)"
we were just talking about this...trying to give credit where credit is deserved...i am always looking for a short cut.
repoe3
__________________
I couldn't repair your brakes, so I made your horn louder.
2009 GSXR 750
2004 Tuono
2004 R1100SBX
Last edited by repoe3; 07-23-2004 at 10:23 AM..
|