[EJP914]

If you are looking to get inside of the fan unit, there are 4 -6 clips that hold the face (has Behr printed in it) to the body of the fan unit. Do not try to pry these off. The plastic tabs they are snapped onto will break off. THen you are SOL. Take a hammer and punch or screwdriver and slide them off to the side. You should now be able to take the face off and look inside at what may be sitting in, on, or around the fan impeller and also what may in the drain tubes. Be careful when you take the face off because the top of it fits into a piece of weatherstripping the encircles the fresh air slots in the cowl. This weatherstrip is usually very brittle and I dont think its made anymore. Getting the face back on into the w/s can be a bear. I have loosened the entire unit from the cowl to get access to the back of it, but have never completely removed it from the car. Too many cables to disconnect. Hope this helps you!