|
Henry, if I remember right, .001" = 25 microns. Therefore the clearance that was mentioned = .0006"-.0018". I ran a 15.0 mm reamer thru my bushings which ended up fitting nicely over my 15mm ground tool steel shafting. The reamer probably cut .0005-.0008" over size. I did not measure after reaming, but it was a nice fit. I also used a die grinder to make a slight oil groove in the id of the bushing to help ensure lubrication.
I have about 2000 miles on the rebuild so far and all is good.
__________________
German autos: '79 911 SC, '87 951, '03 330i, '08 Cayenne, '13 Cayenne
0% Liberal
Men do not quit playing because they get old.... They get old because they quit playing.
|