Gear oil change in a 964 - questions
My 964 has 50,000 miles on it. At the 45K service my wrench did not change the gear oil claiming it wasn't necessary until 60K. I'm not comfortable with that and would like to switch to Swepco anyway. OK, here are the questions:
1. Which Swepco? Manual says 75W90.
2. Looks like the drain plug is a round plug with a 10mm allen head (located just in front of the engine / transaxle, with engine pan removed only). Is this right?
3. Safe to assume that the fill plug is nearby also? Will I need to remove the center pan?
4. Is there a washer (gasket) under the drain plug/fill plug that should be replaced?
5. Considering my mileage, is it necessary to run clean dino for a while before going to swepco?
As always, I am indebted for your assistance.
Mike
|