Bo- I reinstalled mine when I restored my targa top. Here is what I did.
roll the headliner from the front to the middle and back to the middle. you will end up with a scroll shape. There should be cut outs in the center that hide under the outer frame supports. this is your starting reference point. I sprayed a line of 3M adhesive from the support post on the sides. The liner can then be layed on the adhesive layer and aligned. unroll each side(one at a time) and check the alignment. Pay attention to the holes for the clips that hold the top to the frame. YOu will run into trouble if these do not align.
correct alignment if needed. roll back to scroll shape. spray one side with adhesive. unroll and glue the headliner. Make sure to smooth any wrinkles at this point.
I would not press down hard until everything is correct. repeat for the other side of the liner. Congratulations, you just did the headliner.
If you have any questions email me.
jamie
------------------
Jamie
71 911T targa
http://www4.ncsu.edu/~jpnovak
|