|
Registered
Join Date: Aug 2000
Location: Deep in the bowels of UCLA hospital
Posts: 2,316
|
How stiff should a NEW CV joint be
well I bought a new one from PelParts...and I noticed it was pretty damn stiff...I thought is was cuz there was no grease, but even after greasing it was pretty stiff...my old one..albeit broken was loosey goosey...if I picked it up by the outer race, the inner race and ball bearing would move around...but the new one took pushing on the inner race to make it move...
I thought it just needed to be broken in...and I installed it...and no problems yet...any suggestions?
Plus I had to REALLY pound on it (with a rubber mallet) to get it to seat properly on the half shaft...the other came off with my hand
what gives...is this normal?
is this a bad joint??
|