[Manute]

Hi again, i have news!

I found an led in my house so i went to try the blink codes; i ran the car a bit, and the problem appeared again....roughness, 1.2 boost.....ok, I tried the led and it blinked, a pair of blinks followed by another pair of blinks, so i guess itīs code 2-2 according to the chart.

And that means: "knock sensor monitoring"-"knock sensor supplies excessively small or no signal, or K/CP control unit is defective".

After restarting the car, problem and blink code went away, so you were right, itīs a knock relative problem.

I assume K/CP means the KLR chip, so now I need to know which one is the faulty one.

Well, I had no more time today to physically check wiring and knock sensor integrity, but since i donīt have an oscilloscope if I see nothing strange at the wires iīd better replace the sensor.

I just pray for the KLR chip to be ok, itīs quite expensive!