|
Thank you for the suggestion! I have placed the piston into the bore and rotated it to the 20 degree point specified in the shop manual. The piston moved in easily without binding and I could feel it reach and pass over the new seal. Now, when I apply pressure, the "spring' in the center of the piston does not want to let it slide any further over the center pin in the bore. I can depress it about 1/4 of an inch, then it stops and bounces back on the spring to the original point. I am stumped and don't want to force the thing. Do I need to start it at exactlu 20 degrees? This doesn't seem to make sense as the center shaft isn't keyed. Does any of this make sense?
|