[MBEngineering]

HI caevon, If you put your new clutch on so the bolts just hold the center-plate and you can just move it with your finger, through the throw out bearing, then put the box back on and bolt up the box , now through the starter hole tighten up the clutch bolts a little more to hold the center plate in position , turn the flywheel round through the hole in the top of the bell-housing to get to the other bolts , then remove the box and tighten up evenly to pull the pressure plate to the flywheel. and do NOT forget the RING GEAR of the old pressure plate, to put on the new one.

regards mike