View Single Post
jay71 jay71 is offline
Registered User
 
jay71's Avatar
 
Join Date: Nov 2005
Location: Evergreen, CO
Posts: 170
Bryan- thank you for the prompt response!

Question number 2: By any chance was there difficulty found using the stock muffler support bracket? The passenger side header/heater box protrudes to the rear and the crossover pipe mentioned above is in the way of the bracket. The pelican parts diagrams show a different muffler bracket for pre-'86 930s which might work- and I think the exhaust system from GHL is the same regardless of year...so I'm thinking I'm either going to have to cut up and modify my 2-sided muffler bracket or buy an earlier 1-sided one. I could add some spacers but I may run into clearance issues w/muffler. Did anyone encounter this? It's funny- all the vendors sell this stuff claiming it's bolt-on (k27 for example)- just from that description alone you'd think all you'd need for a project that is "bolt on" is a wrench!
__________________
Jay
'86 930
'60 Land Rover Series II SWB

Last edited by jay71; 03-01-2008 at 08:55 AM.. Reason: gramatical error
Old 02-29-2008, 05:44 PM
  Pelican Parts Technical Article Directory    Reply With Quote #3 (permalink)