[tc-sacto]

Finally getting around to installing rebuilt carbs. ( Thanks Jimmy...Mobil Works)

I've been following these instructions, but have come to the end of my knowledge base....it was a short trip!

"STEP 1- Accelerator Pump Volume
Measure the accelerator pump volume at each of the 6 nozzles. Before starting the car, turn the key “on” and energize the fuel pump. Let the pump run a minute or so to fill up the float bowls. The air cleaners are off. Now, lower the vial down the throat of barrel No. 1 and park it directly under the nozzle. Have the assistant in the car depress the gas pedal all the way, nice and easy. Withdraw the vial, record the results on a piece of paper, and dump the contents of the vial. Repeat at each nozzle. (You may have to remove the velocity stacks for cylinders 2, 3 and 6 to gain proper access to the nozzles for those barrels.) Adjust the nut on the accelerator pump rod as necessary. Turning the adjuster nut out will increase the amount injected, and vica versa. You want .6 to .8cc (ml) (.75cc works great). Get them all even. "

I only get gas in barrel number one. None of the others.
1) What gives?
2)Also, do I turn the accelerator rod in or out to get more fuel?

Thnx
Tom