|
Hello
removing is very simple:
undow M6 10mm nut screw on the rear who fix the unit to the bulkhead.
remove the bowdens from the dividerflaps ( mark position, 7mm nut & plier then remove clamp clip ) and the one from the fresh air flap on the fresh air blower.
Then you can go two ways:
remove unit complete with the bowdens on it or pull it some inches and remove the bowdens on the regulator unit.
Have a look at your old unit maybe only the screw in the bulkhead is missing
If your plastic face is broken and moves then you can repair it too ( tricky but possible )
Grüsse
|