|
Registered
Join Date: Feb 2008
Location: Altamonte Springs, Florida
Posts: 342
|
From your photo, it appears to be a case saver.
Having installed both, the case saver is the way to go.
If you are going to install one I would recommend using a squaring jig so that you drill out the existing hole as perpendicular to the mounting face as possible. If you are not going to go that route, buy a number of drill bits that increase in size by 1/32 or 1/16 inch (Max) increments up to the size you will need for the case saver.
By stepping up the sizes of the drill bits you should have more control over drilling the oversized hole without "wandering". Go slow and use lots of lubricating oil...That goes for all drilling and tapping operations...LOL
__________________
FC
'73 911 Track Car
'99 996 Daily Driver
'93 968 Wife's Car
'05 Cayanne S Family Car
|