Quote:
Originally Posted by polizei
We changed out the reference/rpm sensors and tested positive for resistance on the ohm meter, but we still weren't getting any spark. So we swapped from the Protomotive chip out for the stock chip. We got spark immediately, but haven't yet started the engine. I triple checked that the notch on the chip and the notch on the board were aligned. So it currently sounds like I may have received a bad chip from Protomotive. Would I cause any harm if I rotated the chip 180 degrees such that the notches are not aligned? Any suggestions? Thanks guys.
|
Dude, don't install your chip backwards! It probably won't hurt anything, but a phone call to Protomotive would be the first line of attack to me.
__________________
---Les Garten---85 930, Andial IC, GHL Headers, Fabspeed Dual, K-27 HF2, 3.4 JE Full Finned 7.5:1 CR, 964 CAM'd, Carerra 3.2 Manifold Cut/Flipped, Tec3r, Siemans 55#, GSF Fuel Rails, Clewett Crank Trigger, Clewett Cam Trigger,Dual Plugged, ARP Head Studs/Rod Bolts, Clewett Wires.Tial 46mm WG, Tial 50mm BOV, WEVO Shifter,934 Boost Gauge, Wideband EGO Sensor/Gauge, C2T Head Gaskets, '88 MB 300TE,BMW R100RT
|