|
abit off center
Join Date: Feb 2002
Location: At the Airport Kentwood, MI
Posts: 7,311
|
A casesaver is a steel threaded insert, OD is 14X2mm Its really not a DIY job unless you have a mill, I set the case up on my Bridgeport and use an end mill to cut the new hole then use the mill to cut the new thread, I made an install tool which is nothing but a socket screw as you can see, a little loctite and run them in. The mill is used to keep them straight and accurate. I get $175 to do a case, I don't know what others get? I also install a casesaver in the 8mm thru bolt at the lay shaft.
__________________
______________________
Craig
G2Performance
Twinplug, head work, case savers, rockers arms, etc.
|