[911 tweaks]

Hey all, I was wondering if the ones whom have traveled down the road of rebuilding & using weber carbs could give me some tips on what I have ahead of me.

I wish to plan what tools, parts & ref material I will need to rebuild a pair of weber 40ida3c carbs that were previously used on either a 2.0 or a 2.2 size engine.

This is what I have gleamed from the archives so far:
Tools:
1. qty. 2 synchrometers (thx Ronin sor the tip) (pelican p/n pel-tol-stesk)
2. Float gauge (Pelican p/n pel-pmo-004)
3. jet gauge (which tool: #A tool range of 0.45mm-1.5mm OR #B tool1.5mm-3.0mm?)

Reference materials:
1. Wayne's 101 Project book; project 28 to rebuild & 29 for tuning
2. BA book pg 153-155
3. Weber tech manual by Bob Tomlinson
4. Weber Tech manual by Pat Braden
5. Weber factory tuning manual

Parts needed:
1. what rebuild kit as pelican is out of stock ?
2. engine is an 82' stk 3.0 w/ stk cams... what size carb parts do I need & where get ?
3. If I was to use 964 cams, would different carb jetting, ect. be needed?

Thanks in advance to all that can help me out!
Bob