[Kroggers]

This is probably a quick and easy question, but i am not 100% sure what to do so thought I would see what others have done.

On my SC there are two smaller wires with the spade terminals going to the factory starter. One comes from the ignition switch, and the other is for the cold start. On the new high torque starter, there is no connection for the cold start. I am inclined to wire both the ignition and cold start wire to the terminal on the starter motor, so that voltage is also supplied to the cold start circuit when the starter is engaged.

Looking at the diagrams for the starter circuit, this is in effect what happens within the factory starter motor anyway.

What did others do with the cold start wire when they installed the high torque starter?