|
If you are having trouble removing the wrist pins (I have) I made a tool that was a bar with a slight hook welded and ground on one end, and a thread for a nut/slider bar on the other. It wont take a lot, but it was enough. Make the bar/hook diameter just enough to slide thru the pin- so you dont have much sloop/leeway.
Alan
__________________
83 SC, 82 930 (track) - Stock except for RarlyL8 race headers, RarlyL8 Zork, K27-7006, 22/28 T bars, 007 Fuel head, short 3&4 gears, NGK AFR, Greddy EBC (on the slippery slope), Wevo engine mounts, ERP rear camber adjust and mono balls, Tarret front monoball camber adjust, Elgin cams, 38mm ported heads, 964 IC. 380rwhp @ 0.8bar Apart from above, bone stock:-)
|