[pkfrdh]

pnzr911,

The brand name of a good plastic epoxy welder is DEVCON. It definately makes a big difference if you rough up all the mating sirfaces. This stuff works even on the kind of rubber plastic that sunglasses are made of. You only have about two minutes of working time depending on the temperature. Have everything ready to go and mix the amount needed to cover both surfaces and have extra applied to create a bead that will increase the surface area. Don't skimp with it.

Good luck...it should hold after this.

The urethane sounds good too...very strong and still flexible. Gorilla Glue is one brand in small containers. This stuff reacts with moisture in the air and once you open up a container, it tends to all harden no matter what you do. Buy the smallest container. Sold at most hardware stores. Not sure about fuel resistance.

JGL