Quote:
Originally Posted by magnuskgc
You don't happen to have pics or anytihing that would assist in routing the wires in to the seat?
|
No pics, but there's no real trick to routing except to position the wire bundle so it doesn't pull sideways against any of the motor connectors. The only hard part about this is that the opening in the seat frame & bolster is small and hard to thread the new switch's wire bundle through. I found that a pair of long foreceps was really helpful. Also forgot to mention that once you get it threaded through properly, zip-tie the wire bundle to the wavy spring on the seat bottom to: a) remove some of the strain on the wires and connector, and b) reduce the likelihood that the wire bundle might get snagged.
Good luck
Dale