Hi everyone,
I finally got around to installing my interior goodies today. Officially my first major p-car project
. After a pain in the butt bolt that decided to strip was finally ground off and the thread taken out of the hole (to remove the stock seat) I was able to mount my passenger side SPG.
I always see that its better to go through with the drilling when mounting the harness. However I can't seem to find any pictures or information on where to put the holes to mount the inner lap belt (coming from console side). Anyone know where a good point is to drill and attach this belt and the sub belt. Any pics or vivid descriptions would be greatly appreciated (I wanna get this done before the weekend so I can actually seat a passenger). Also, are there any good ways to make these mounting points watertight?
So far I've removed the fold down seat backs, the rear belts and buckles, and rear sound padding. As well as mounting a harness bar and lens protection. That slippery slope sure does go fast.
Thanks in advance.